Carbon arc lamp weather resistance test chamber_DONGGUAN Q1-TEST ENVIRONMENT EQUIPMENT CO., LTD

Product Parameters

Product Introduction
Product Features
Application Field
Product Parameters

Carbon arc lamp weather resistance test chamberIntroduction

The weathering test chamber for carbon arc lamps mainly uses daylight type carbon arc lamps as the light source. By changing the temperature (sample temperature, studio temperature), relative humidity, rainfall, etc., the comprehensive combination of light, heat, and water under the conditions of outdoor climate test chambers is simulated to conduct artificial aging tests on the photochemical and mechanical properties of the test materials.

Product Features

Adopting a PLC touch screen controller, the control is stable, with main control parameters including light irradiance, studio temperature, sample rack temperature, and relative humidity. It can automatically control in a closed loop.

Application field

Product Parameters

Model	QSC-1300
Studio size	110x110x110cm(WxDxH)
Outer box dimensions	130x140x205cm(WxDxH) Subject to actual size
Use the light source	Sunshine Carbon-Arc Lamp
Time for each cycle test	60 hours, 4 sets of carbon rods each use

Temperature and humidity range of use: based on the black panel temperature.
Temperature range	40~70°C, black disk thermometer is 63+3*C or 83±3°C
Humidity range	Black disk thermometer for 63: +3°C, humidity 50 ± 5%
Environmental conditions	Room temperature 25: ±3°C, relative humidity: 65±20%
Temperature control method	Electric control gate, automatic adjustment of intake and exhaust, balance control temperature
Humidity control method	The immersive electric heater generates steam to balance the humidity
Simulated rain spray cycle control	Spray time can be set
	Spray for 18 minutes every 120 minutes (- general rain cycle)
	Spray for 12 minutes every 60 minutes (rainy type rainfall cycle)
	No spray (dry rain cycle)
Spray water properties	At a spray pressure of 1.0 kgf/cm? the total water flow rate from the nozzle is 2.10 ± 0.10 L/min.
Customer water supply	10E1 Water pressure 1.5~3.0 kgf/cm²
Water quality	PH6.0~8.0 Hard water softener or pure water device should be used when necessary.
Structure and material	The test slot is made of SUS304 stainless steel plate. The main body shell is made of steel plate and treated with spray painting.
	Test slot door with anti-ultraviolet window
	The insulation layer is temperature-resistant PU foam.
Rainfall cycle time control	Power outage memory device (0~999min) with flow control: two-stage pressure regulation, pressure gauge and flow meter (0~ 3.01/min).